Texas 4x4 Forum banner

Hello from east texas..

2K views 17 replies 13 participants last post by  dragoonranch 
#1 ·
Hey all, i've been on and off the forum so i figure i should say hello. Im over here in Quitman, bout an hour north of tyler. Current build is a 95 yj with a 396 on propane. 2.5 ton rocks, 5 ton double beadlocks on 49 inch michelins. custom alcan springs abnd a 120 inch WB. if your in my area gimme a shout. I would like to meet some fellow wheelers in my area.
 
#4 ·
Welcome!
 
#7 ·
Welcome to Texas4x4.org
 
#10 ·
Whats up Glen.. yeah this is josh.. i figured i would get on here and meet some peeps lol.

Here is a pic of my rig.. welder




 
#15 ·
No lol.. unless you want to tow me. I gotta build driveshafts, shock mounts and plumb the propane. And then theres the uber expensive hydraulic steering that i still havent convinced my wallet that i need at the moment..fightte
 
#16 ·
Here you go, this is what you need from PSC. This is an email I got back in December. Get er' dun!!

Rockwell Full Hydraulic Steering Kit (P-SERIES PUMP)
SC-2217 PSC-SC16
FH-CLC04 SP-1405KX
TRK-120 HK-2085K
FH-PSC200/3 BK-MB22
PX-B10
Runs $1495.00

To add rear steer
RSCV-VIC $265.00
SC-2217 $340.00
PSC-SC16 $120.00
TRK-120 $147.60
HK-2086 $148.00
PX-B10 $19.75
DER-13253 $75.00
 
#17 ·
Thank you so much for the helpful push.. lol.. im looking into it.. i just bought a bender and i got a few little things to do to it and itll be ready.. sooner than later hopefullybsflg
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top