Texas 4x4 Forum banner

Yoda Stuff SATX

1K views 16 replies 4 participants last post by  mnmstoy 
#1 · (Edited)
Top shift transfer case. Told it was good and kept inside. It has surface rust and is missing shifter. Has 10mm flanges so its newer then 1981 $100
CV half of a front 83+ drive shaft. No slop in u-joints. 10MM flange holes $50 PENDING
No - The T-case does not come with it nor the flange bolts.

Shackles About 6" eye to eye on the shackles come with grease-able bolts $30

I also have rear leafs. for some reason they dont have a mil wrap up front. $20 for the pair. Missing bushings on one. 79-81 leafs.
Degree shims 1 pair $5 their still on the axle.
1985 rear end minus third member FREE come get it before I start cutting stuff off of it. You will have to take off the leafs for me. Come on------ a little work for FREE. bigok
Cross member 1985 $5
Rear Bump stops $5
Front aftermarket leafs. I dont know who made them. 2-3" lift it seems. Nice bushings $20
Mike

no shipping and first with cash in hand takes it home.
 
See less See more
2
#2 · (Edited)
I also have two sets of Stock Axles birfs/inner axles shaft.
One set ready to go. The other set is still in my truck... but should be available in a week are two.
$50 a set.
Mike


A set (4 each) of rollers/rim fits Toyota 6 lug. two hold air, two hold air for a day. FREE
something like 15X6 rims
Mitch has first dibs...sence I got them from him...for free.
 
#7 ·
Sorry inside is a little over 2.5" Made for Toyota. Will not fit Chevy.
Mike


If I get around to that. I posted in my first post. "no Shipping" I have lots of stuff going on. Please understand.
 
#5 ·
4 fat fingers on the shackle. I can check after work tomorrow.

If it rains Joel that's cool we can meet up. But I have front seats to install...if it dont rain. I need my Yoda back on the Road ASAP.
Mike
 
#9 ·
10-4 I wont get around to thinking about shipping until maybe Thursday of Next week.
But, I'll keep you in mind.
Mike
 
#12 ·
I'll pass on the wheels but thanks Mike.
 
#15 ·
The tube insert on the chassis is something like 5" wide and if you notice. The stock shackles go from really wide (chassis side) to 2.5"
Here is a picture of the ones I made. Sorry for the terrible spacers I have on the bottom. I need to order 3/4" spacers for the bottom. These would be called wide shackles.


But i will sell them to you. I just dont want to sell you parts that wont work on your application. BTW price does not include shipping.
Mike
 
#16 ·
i know what shackles i would need in the front because of running chevy axles. but i wasnt going to use them for the frame side of the springs, im going to do something different.

i already ask what shipping would be to 76266.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top