Texas 4x4 Forum banner

8 lug outers and lots of misc 10b parts

3K views 8 replies 2 participants last post by  gonefishin 
#1 · (Edited)
lots of misc 10b parts added parts updated

i bought a set of 8 lug outers for my 10b from another member on here and never used them got a d60 instead

i have the hubs rotors and caliper mounting bracket i cleaned up everything and repacked the bearings rotors are grooved i was going to use them but you may not also comes with a set of non flat top knuckles and spindles
sold

also have another set of non flat topk knuckles $20

2 spindles need new bearings sold

6 lug hubs rotors and caliper bracket needs bearings on one side $25 for both sides

warn prem hubs sold

factory hubs never tried them but everything looks good sold

30 spline front shafts 1 new super u joint on long side short side feels ok 1 stub is a little scored from bad spindle bearing not too bad full set sold

welded 30 spline open case sold

4.10 gears light surface rust looks to be ok sold

front housing $20

30 spline limited slip works great sold

30 spline rear shafts $30 each or $50 for both sold

Factory yokes I have 2 15 each

Raised steering arm $25

Dual shock steering stabilizer $25

The rest of the factory steering components drag link etc $???
 
See less See more
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top