Texas 4x4 Forum banner

Looking for NP241 32 spline chevy

1K views 8 replies 4 participants last post by  jwilson 
#1 · (Edited)
Looking for NP205 or NP241 32 spline chevy

Hi, I'm looking for a NP 205 from a TH400 with 6 holes or NP241 with 6 holes that has 32 splines for a Chevy.
Or if you have an adapter with 8 bolts on the NP205 side and came from a TH400 I would buy that.
I have 2 NP205s however they both are mated to SM465s with the 8 bolt pattern.
Mating it to a 4L80E.
Currently I have a borg warner 4401 transfer case mated to it and it has a driver side drop and I need a passenger side drop.
If you want to trade for my 4401 or I will pay cash.
Located in the Houston area.

Thanks!
 
#4 ·
After help from Texas4x4 members, I am now looking for an adapter for a 205 8 bolt pattern on the NP205 side to a TH400/4L80E round 6 bolt pattern or a NP 205 w/ 32 spline input shaft with the 6 bolt pattern.
If you have one, please let me know.
I have cash in hand!

Thanks!
 
#5 ·
If you don't me helping out ?

What your looking for is a turbo 400 NP205 with the 6 bolt round pattern. Make sure it's the short shaft input for the 205. All that should need done is to redrill the pattern on the 6 bolts, I think they were different between pass side drop and drivers side drop.

Same isuue if you find a 241. :toast:
 
#7 ·
i do know that the factory 4l80/205 used the long input gear. not the short.

the 205 he wants can come from an sm465 or a th400 1985 and newer or just skip all this bull and get the hens tooth of the factory 1991 4l80/205 adapter. that one is even VSS like he would need...

you can use a th400/205 adapter with a small spacer/ring between the trans and adapter.

there is a GIANT thread on CK5 about this.


IMO i would skip the 205 and just get the damn 27 spline 241 for $100 at a junkyard, $89 input gear and a $150 rebuild. those 32 spline pass drop VSS cases are equally as hard to get but 241 is a very nice case.
 
#9 ·
Thanks obijuan and crewcab88!
I picked up a NP205 32 spline that was mated to a TH400 (86 or 87 I believe) from pirate last night. Guy is going to stick it on his buddies truck for $40 bucks and it will be here this weekend!
Looks like I need to go do some reading to mate it to my 4l80e (a spacer ring?).
I wanted the NP205 so I can dual stick it. crewcab88 suggested it on my other post and I liked the sound of it.
This K5 is my play a little bit Blazer, I have another K5 that is getting rockwells (when I can find them for cheap enough), that is my lots of fun blazer. I have a NP203, 2 NP205s (8 bolt ones) mated to SM465s so the other Blazer is pretty much figured out just need the axles now.
This K5 is just in progress, I want it to be fun enough, yet not the one I go thrash so I can still drive it on the street and drive it to where I want to go have fun.

Thanks for all your help and suggestions, they all truly help !!!
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top