Texas 4x4 Forum banner
1 - 2 of 2 Posts

· Registered
80 Posts
Discussion Starter · #1 ·
Hey guys, I was wondering if anyone knew who can translate casting numbers on an engine block and a front axle. I know I have a 400 sbc but dont know the year on it, And I am pretty sure the front end I have is a dana 44 8 lug but it doesn't have any markings, just numbers.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.