Texas 4x4 Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
355 Posts
Discussion Starter · #1 ·
I have two front driveshafts for mid 80's blazers and both wont fit mine cuz i swapped in a TH350/NP203 in place of the 700r4/208. Is there anyway to get them to fit without dishing out $100 at the driveshaft shop. Anyway to shorten them yourself (I do know how to weld and have access to all different types of welders, cutters exc...) I would buy a nice new shaft to replace it but im fixin on changin my whole drivetrain up anyway so why spend $300 for 2 months use of a drive shaft? Any suggestions?
Thanks
Dennis
 

·
Registered
Joined
·
11,141 Posts
I have two front drivehafts for a 203 Chevy. I don't need them, I swaped to a divorced Dodge 205 with 1350 yokes. I'm pretty sure they are for a stock lift though. Any other questions let me know.
John
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top