Texas 4x4 Forum banner
1 - 1 of 1 Posts

· Registered
23 Posts
Discussion Starter · #1 ·
When the motor is running, it looks like the flywheel is warped....kind of dances back and forth about 1/8 inch, maybe 3/16. the torque converter looks good though, no dancing. should I be concerned about it, will it destroy my new motor bearings or tranny input bearing? I don't feel any vibrations or anything like that when I drive down the highway at a high rate of speed...but then again I do have 35's, 6" lift, and sucky factory gearing. need to get some 33's.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.